There are a ton of (cheap) generic nylon options if you need to securely mount a holster to MOLLE on a vest or inside a pack. However, I’ve always preferred injection/thermo molded polymer or kydex for its customized fit, retention and ease of re-holstering. I needed a new MOLLE-compatible holster for my Triple Aught Design Control Panel 1. I found the Craft Polymer Molle Holster after doing some research online and asked the company to send over a sample that would fit my carry gun – the Walther PPQ M2. It arrived a few weeks later.
Craft Thermo Molded Polymer Molle Holster
Out of the box, I was immediately impressed with the fit and finish. The backing is made from a padded mesh and Cordura nylon with plenty of rivets to secure the thermo molded shell. Two very stout straps attach the holster to MOLLE or a 2-inch belt for Outside the Waistband carry.
The snaps say “Vega Holsters”, which is the overseas Italian company that manufacturers this holster for Craft. So far, the snaps have proven to be very solid. The back of the straps also have hook material that will further lock in the holster if the panel or belt has loop facing material.
The fit with my Walther PPQ was good. The barrel and trigger are both fully protected and there’s a sight channel. The firearm clicked into place and stayed there once I tightened the retention screw with the included Allen Wrench.
Retention I’d say was adequate to the task. Not the worst I’ve seen in a made-to-order holster and not the best. I did notice there was a tiny bit of up and down play and an impromptu stress test, consisting of a couple of hard inverted shakes, did manage to dislodge the firearm. But, for typical bag carry, it’s good enough and certainly a big improvement over any generic nylon holster. Craft also includes a bungee strap for added security if needed.
The Craft Polymer Molle Holster is covered under a 2-year warranty and retails for $47.95. It can be purchased here from Craft’s website for a large number of firearm makes and models and is available in three colors – black, coyote and olive.
The post Craft Polymer Molle Holster Review appeared first on .